iPECS eMG80 - Page 320

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
307
2. Press the [VOL UP]/[VOL DOWN] button to scroll through the CLI Messages.
5551122323
21/11 09:10 CNT: 2
1. Press the “*” button, the next CLI message is displayed.
To delete the current CLI Message
Or
1. Press SELECT>, and choose DEL CUR in case of using Phone with soft button.
1. Press the [SPEED] button.
To delete all CLI Messages
2. Press the “*” button twice.
Or
1. Press SELECT>, and choose DEL ALL in case of using Phone with soft button.
1. Press the [HOLD/SAVE] button.
To return a call to the current CLI Message
Or
1. Press SELECT>, and choose ANSWER in case of using Phone with soft button.
1. Press SELECT>, and choose SAVE in case of using Phone with soft button.
To save the CLI Message to a Station Speed Dial
Conditions
1. The total number of Message Wait indications in queue for the system is 1000 (eMG80)
and 4000 (eMG800/UCP). Should the message Wait buffer fill, the buffer full message,
as below will be output over the RS-232 port.
“Warning: Message Wait Buffer Full.”
2. The CLI Message Wait display includes the date, time, message count and caller Id.
The count is the number of attempts by a specific calling party with the time and date
from the most recent attempt.
3. The CLI Message Wait status is stored in non-volatile memory to protect against power
loss.
4. When an outside call is assigned to ring multiple stations, or a group, CLI Message
Wait is not provided.
5. When an outside call with CLI is routed to an ACD/Terminal/Circular station group, the
CLI Message Wait will be provided to the last station notified of the call before the call
was abandoned.
6. Once a call is answered by a station in the system, CLI Message Wait is no longer
available i.e.; transferred calls do not provide CLI Message Wait.
7. A CLI Message Wait indication is left at the originally called station even if the call is
forwarded to another station.
8. While idle, the user may toggle between CLI number and CLI name, if available, by
pressing the [TRANS/PGM] button.
9. The CLI and called station number will be shown in the SMDR record as an
abandoned or lost call.