iPECS eMG80 - Off-Hook Signaling

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
366
1. Lift the handset or press the [SPEAKER] button to receive a dial tone.
To activate ICR Call Forward
2. Press the [FWD] button.
3. Dial the desired Call Forward code (0-4).
4. Dial “*587”, the Station ICR code.
5. Replace the handset, return to idle.
1. Activate ICR Call Forward.
To activate/deactivate a Profile from your phone
2. Press the [TRANS/PGM] button and dial “26”, the Call Profile menu.
Or Log in to the Station Web portal.
3. Select the Call Profile Table desired (“0”: ICR or “1”-“3”: Call Profile 1-3).
1. Call to iPECS System (DISA CO Line).
To change Call Profile while away from your phone
2. Dial “#” to access your Voice Mailbox.
3. Enter your Station Number and Authentication code.
4. Dial “7” to set call forward.
5. Enter “1” to set Station Call forward.
6. Enter “Station ICR Code”.
7. Enter “Call Profile Number” (0: ICR Forward, 1-3: Call Profile 1-3).
Conditions
1. Call Profile Routing is available on digital and IP Lines only and is applied to outside
calls that are routed to your phone as a Transfer, DID or DISA call. Calls that are
assigned to Ring to your phone are not subject Call Profile Forward.
2. The conditions associated with Station ICR apply to Call Profile Routing.
3. It is recommended hunt group is set last call profile destination.
Programming
Keyset Admin.
STATION
Call Forward (PGM 111-Button 2)
Station Call Forward No Answer Timer (PGM 123-Button 1)
SYSTEM
System Call Forward No Answer Timer (PGM 181-Button 1)
STATION DATA
Web Admin.
Common Attributes Call Forward
Station Timer

Station Forward No Answer Timer
SYSTEM DATA
System Timers

Call Forward No Answer Timer
Related Features
 Call Forward
 Station ICR
Hardware
 iPECS IP or LDP Phone