iPECS eMG80 - Outside Line Name Display

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
368
• DSS button
Introduction of various types of call-queuing (incoming/making /talking/held call) buttons
 Assignment of a specific station number
 Call-queuing from/to the specific station number
 Presence of the station status
• CO channel button
 Assignment of a specific CO channel
 Call-queuing for an external calling/receiving/held call via the specific CO channel
 Presence of the CO channel status
• CO-Group button
 Assignment of a specific CO-group number
 Call-queuing for an external calling/receiving/held call via the specific CO-Group
 Presence of the queued call on the button
• CO-LOOP button
 Assignment of a special type 'LOOP' for non-specific/random/whole-range of CO
channels
 Call-queuing for an external calling/receiving/held call via the button
 Presence of the queued call on the button
• MSN-LOOP button
 Assignment of a external DID telephone number
 Call-routing of an incoming external call with called party number to stations who
have MSN LOOP buttons with same DID telephone number as the incoming called
party number
 Call-queuing and presence of status of the incoming external call
 Call-queuing and presence of status of an outgoing external call which was created
on the button when make a call by pressing the button.
 Multiple buttons assignment with same or different MSN telephone number
 An option : MSN Wait = OFF/ON (second incoming MSN routing call allow = yes/no)
• Unified-LOOP button
 Assignment of coverage of my station number
 Multiple buttons assignment
 A button can have an receiving/making/held call for both type of internal and external
call
 DSS/CO/CO-Group/CO-LOOP/MSN-LOOP button goes first than Unified-LOOP
button
 (An incoming call is presented on related DSS/CO/CO-Group/CO-LOOP/MSN-
LOOP button at first, the call is presented on an Unified-LOOP button at second
priority)
Do not need to enable "call-coverage-mode" feature for utilization of this button.
Operation
iPECS IP & LDP Phones
Keyset
[TRANS/PGM] + {FLEX} + [TRANS/PGM] + “34” + [HOLD/SAVE]
To assign a {Call Wait} button
1. Press the {Call Wait} button.
To activate/deactivate call wait
2. Dial activate/deactivate code, “0: Off”, “1:For External/Internal”, “2:For External”, or “3: For
Internal” respectively.