iPECS eMG80 - Page 80

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
67
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + “*588” + [HOLD/SAVE]
To assign a {Pickup Group Pick-Up} button
1. Lift the handset or press [SPEAKER] button.
To Pick-up a call ringing at another station in the same Call Pick-up group
2. Dial “*588”, the Pickup Group Pick-up feature code.
Or, Press the {Pickup Group Pick-Up} button.
SLT
1. Lift the handset.
To Pick-up a call ringing at another station in the same Call Pick-up group
2. Dial “*588”, the Pickup Group Pick-up code.
Conditions
1. Pickup Group Pick-up applies to stations within the same Pick-up Group and does not
apply to other types of Station Groups where Group Call Pick-up may be used.
2. To pick-up an outside call, you must have an idle appearance button available.
3. When several calls are ringing simultaneously, Call Pick-up will connect the oldest
highest priority call (Ringing Line Preference, PGM 173 or System Data Ringing Line
Preference Priority).
4. Queue callback and Private Line calls are not subject to Call Pick-up and such
attempts receive error tone.
5. Hands free announced intercom calls cannot be picked up by another station. Only
ringing intercom calls are subject to Call Pick-up.
6. When a station belongs to multiple Pick-up Groups, calls to the group with the lowest
number are answered first.
7. A Station must have “Pick up by Button” enabled to use a Flex button for Pickup Group
Pick-up.
Programming
Keyset Admin.
STATION GROUPS
Pick Up Group (PGM 192-Button 1)
STATION
Pick up by Button(PGM 114-Button 20)
SYSTEM
Ringing Line Preference Priority (PGM 173)
STATION GROUP
DATA
Web Admin.
Station Group Assignment Group Type, Pick-Up Attribute
STATION DATA
Common Attributes

Pick-Up by Flex Button