iPECS eMG80 - Page 84

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
71
1. Press the [TRANS/PGM] button.
To transfer an active call with Screened Call Transfer
2. Dial the station to receive the transfer.
3. At answer or splash tone, announce the call.
4. Hang-up to complete the transfer.
Or,
1. Press the {DSS/BLF} button for the desired station.
2. At answer or splash tone, announce the call.
3. Hang-up to complete the transfer.
1. Press the [TRANS/PGM] button.
To transfer an active call with Unscreened Call Transfer
2. Dial the station to receive the transfer.
3. Hang-up to complete the transfer.
Or,
1. Press the {DSS/BLF} button for the desired station.
2. Hang-up to complete the transfer.
SLT
1. Momentarily depress the hook-switch.
To transfer an active call with, Screened Call Transfer
2. Dial the Station number to receive the transfer.
3. At answer or splash tone, announce the call.
4. Hang-up to complete the transfer.
1. Momentarily depress the hook-switch.
To transfer an active call with Unscreened Call Transfer
2. Dial the Station number to receive the transfer.
3. Hang-up to complete the transfer.
Conditions
1. The transferring station may camp a call on to a busy station.
2. The LED of a {LOOP} or {POOL} button will display the status of an outside call until
the station no longer has call supervision i.e.; the call is successfully transferred.
3. To prevent Toll abuse, outside Lines without an active call (either incoming or dialed
digits on outgoing) cannot be transferred.
4. For outgoing calls on analog Lines, the system will monitor the Line for dial tone to
prevent Toll abuse.
Programming
Keyset Admin.
STATION
No Touch Answer (PGM 111-Button 6)
SYSTEM
Transfer Recall Timer (PGM 180-Button 7)