Kentrox RMX-3200 - Page 100

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring the Bridge Group: Configuring Controllers for Bridging
9-4
4. (optional) Verify that the controllers on bridge group switch have been configured
properly:
show controllers bridge switch
The command response similar to the following displays:
5. Save the configuration.
(Dub)>show controllers bridge switch
bridge switch system-name=br_switch status=enabled oper-state=up stp=enabled
forward-delay=15 hello-time=2 max-age=20 priority=32768
description=10/100 ethernet switch
ethernet 1 cost=100 priority=128 stp_state=forwarding stp_root_port
ethernet 2 cost=100 priority=128 stp_state=disabled
ethernet 3 cost=10000 priority=120 stp_state=disabled
ethernet 4 cost=100 priority=128 stp_state=disabled
ethernet 5 cost=100 priority=128 stp_state=disabled
ethernet 6 cost=100 priority=128 stp_state=disabled
serial wan/1 group cost=100 priority=128 stp_state=unmanaged
serial 5 cost=100 priority=128 stp_state=unmanaged
(Dub)>