Kentrox RMX-3200 - Configuring the Site LAN

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring a Site VPN Connection: Configuring the Site LAN
8-5
Configuring the Site LAN

Note: The type of interface to be used for the site LAN must be decided upon before
a site VPN connection can be configured. In the following scenario,
ethernet
port 3 interface is used.

Note: In order to configure the site LAN, first remove the ethernet controller from the
bridge group.
To configure the site LAN:
1. Remove controller ethernet 3 from the bridge group:
config controller ethernet 3 no bridge
2. Configure IP address 192.168.111.1/24 for ethernet port 3:
config interface ethernet 3 ip address 192.168.111.1/24
3. Enable IP forwarding:
config ip forward
In this scenario, you will:
 Remove the ethernet controller from the bridge group
 Configure the IP address for the ethernet controller
 Enable IP forwarding