Kentrox RMX-3200 - Configuring T1;E1 Line Encapsulation Settings

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Controllers and Interfaces: Configuring T1/E1 Line Encapsulation Settings
7-7
Configuring T1/E1 Line Encapsulation Settings
To configure the T1/E1 line encapsulation settings:
1. Configure PPP encapsulation for controller
serial wan/1:
config controller serial wan/1 channel-group group encapsulation
ppp
2. (optional) Configure a default route for PPP encapsulation that uses the same
subnet as the corresponding interface:
Important: This command overrides the default route assigned to Remote RMX-
3200 via command
config ip route default.
config controller serial wan/1 channel-group group encapsulation
ppp defaultroute
3. Configure the local authentication method as chap for controller serial wan/1:
config controller serial wan/1 channel-group group encapsulation
ppp local method chap
4. Configure local username userb and local password secretpass for
authentication on controller
serial wan/1:
config controller serial wan/1 channel-group group encapsulation
ppp local identity userb secretpass
5. Configure maximum number of data bytes that can be received (mru) in a single
PPP frame as
5200 on controller serial wan/1:
config controller serial wan/1 channel-group group encapsulation
ppp mru 5200
In this scenario, you will:
 Configure PPP encapsulation for a T1/E1 serial controller
 (optional) Configure a default route for PPP encapsulation
 Configure the local method and local identity for authentication
 Configure the MRU and MTU values
 Configure the remote method and remote identity for authentication
 Configure the inactivity timeout
 Configure the T1/E1 serial controller with PPP encapsulation for bridging (BCP)
 (optional) Configure HDLC encapsulation for another T1/E1 serial controller.