Kentrox RMX-3200 - Configuring SNMP

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Network Setup Parameters: Configuring SNMP
5-13
Configuring SNMP

Note: The following management information bases (MIBs) are available for Remote
RMX-3200:
 aiMediationV2.mib
 aiPeriphDiscrete.mib
 aiPeripheral.mib
 aiSysCfg.mib
 aiSysCfgConfig.mib
 aiSystem.mib
 aiSystemInv.mib
 aiRosetta.mib
To access the available MIBs for Remote RMX-3200, go to:
http://www3.kentrox.com/Support/Documentation-Library.aspx.
To configure SNMP:
1. At the main prompt, configure an SNMP version 1 community string named
newadministrator and assign read-only access to objects in the MIB:
config snmp community public v1 readonly
2. Configure a management station with IPv4 address 10.34.3.84, port number
162 and community string public for sending SNMP traps:
config snmp host 10.34.3.84 162 public v1
In this scenario, you will:
 Configure an SNMP version 1 community string
 Configure an IPv4 SNMP management station
 Configure an IPv6 SNMP management station for version 2 inform requests
 Enable authentication trap transfer
 Enable the SNMP trap queue
 Configure the priority level on a trap OID

Notes: This scenario applies only when an SNMP management system, such as
AppliedView, is used to manage Remote RMX-3200.