Kentrox RMX-3200 - Configuring an NE Set

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Modules: Configuring Modules Using Command Line Interface
24-7
Configuring an NE Set
To configure an NE set:
1. At the main prompt, configure NE (instance)
Tenant1Power in NE set
TenantPowerMeter:
config site network-element-set TenantPowerMeter instance
Tenant1Power

Note: NE (instance) names (for example, Tenant1Power) must be unique within
the site. In addition, a module may define a format to which the NE name
must conform. For example, the module may allow you to enter any
characters for the beginning of an NE name but require that the name end
with certain characters (for example,
Power). To view the name format,
execute the command
show site network-elements-sets <NE Set>.
The “Name Restriction” field shows the format.
2. Configure description
This is Tenant1Power. for NE (instance) Tenant1Power
in NE set
TenantPowerMeter:
config site network-element-set TenantPowerMeter instance
Tenant1Power description This is Tenant1Power.
3. Configure display name Tenant1PowerMeter for NE (instance) Tenant1Power in
NE set
TenantPowerMeter:
config site network-element-set TenantPowerMeter instance
Tenant1Power display-name Tenant1PowerMeter

Note: NE (instance) display names, which are used within the Optima
application, must be unique within the site.
4. Configure NE (instance)
Tenant2Power in NE set TenantPowerMeter:
config site network-element-set TenantPowerMeter instance
Tenant2Power
5. Configure description This is Tenant2Power. for NE (instance) Tenant2Power
in NE set
TenantPowerMeter:
In this scenario, you will:
 Configure two NEs (instances) in a network element set.
 Configure a description for each NE (instance).
 Configure a display name for each NE (instance).
 Show information for the NE set and NEs (instances).