Kentrox RMX-3200 - Disconnecting a Managed Expansion Peripheral

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring the Peripheral Management Subsystem: Disconnecting a Managed Expansion Peripheral
25-22
Disconnecting a Managed Expansion Peripheral
When Remote RMX-3200 is disconnected from a managed peripheral, a trap is
generated. Remote RMX-3200 notices physical disconnections 20 to 30 seconds
after they occur.
To disconnect a managed expansion peripheral, configure the unit
2 expansion
peripheral to become unmanaged:
config peripheral 2 no manage
When Remote RMX-3200 is reconnected to an expansion peripheral after a
temporarily disconnection:
 Output state changes that occurred during the disconnection are applied to the
output’s points.
 Events are generated that report on the current state of enabled expansion
peripheral inputs. This includes changes that occurred and persisted during the
disconnection.
In this scenario, you will disconnect the managed peripheral unit.