Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Users in the CLI: Adding a New User
3-2
Adding a New User
To add a new user:
1. At the main prompt, add a new user with user name
johndoe and assign profile
status:
config users add johndoe status
2. At the password prompt, enter the new password. Note that the characters that
you enter do not display, but display as asterisks:
**********
3. When prompted to confirm, enter the same password. Again, the characters that
you enter display as asterisks:
**********
Notes: User names and passwords are case-sensitive.
Available profiles are status, management, supervisor, and
restricted. For more information on these profiles, refer to the Remote
RMX-3200 Command Reference Guide.
4. (optional) Verify that the new user has been added properly:
show users
The command response displays similar to the following:
5. Save the configuration.
In this scenario, you will add a new user.
(Dub)>show users
Login Name Profile
1. janedoe supervisor
2. johndoe status
3. test supervisor
(Dub)>
To Next Page
Loading...
