Kentrox RMX-3200 - Initiating a Control Action

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Modules: Configuring Modules Using Command Line Interface
24-8
config site network-element-set TenantPowerMeter instance
Tenant2Power description This is Tenant2Power.
6. Configure display name Tenant2PowerMeter for NE (instance) Tenant2Power in
NE set
TenantPowerMeter:
config site network-element-set TenantPowerMeter instance
Tenant2Power display-name Tenant2PowerMeter
7. (optional) Verify that the NE set has been configured properly:
show site network-elements-sets TenantPowerMeter
The command response similar to the following displays:
8. Realize NE (instance)
Tenant1Power and Tenant2Power using scenario
Realizing and Configuring Network Elements on page 24-14.
9. Save the configuration.
Initiating a Control Action

Note: In this example, the fan network element provides the fan-controller
control. Controls will automatically go to the “online” state once the host
(Dub)>show site network-elements-sets TenantPowerMeter
Name - TenantPowerMeter
Description - NE Set for TenantPowerMeter
Category - PowerMeterCategory
Max Elements - 3
Name Restriction - (.*Power)
Instances
------------------------------------------------------------------------------
Name - Tenant1Power
Description - This is Tenant1Power.
Display Name - Tenant1PowerMeter
Activity State - Active
Name - Tenant2Power
Description - This is Tenant2Power.
Display Name - Tenant2PowerMeter
Activity State - Active
(Dub)>
In this scenario, you will:
 Initiate the control action to turn on the ventilation fan
 Show the state of the controls