Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Modules: Configuring Modules Using Command Line Interface
24-9
network element is “online” and all the control’s required parameters that do
not have default values have been configured.
To initiate a control action:
1. Select the
run action for control fan-controller:
exec site control-action fan-controller run
2. (optional) Show the current state of all controls:
show site controls
The command response similar to the following displays:
Tip: To display the details for control fan-controller, enter show site controls
fan-controller
(Dub)>show site controls
Control Category State Admin
------------------------------------------------------------------------------
fan-controller VentilationFan Running enabled
To Next Page
