Kentrox RMX-3200 - Configuring RAS Settings

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Network Setup Parameters: Configuring RAS Settings
5-11
Configuring RAS Settings
To configure RAS settings:
1. At the main prompt, configure the RAS server type as
tacacs+ with fallback
enabled:
config ras shell tacacs+ fallback

Note: A message displays indicating that the shell type configuration will not
take effect until the server is configured.
2. Configure the primary RAS server with the following settings:
 IP address 10.50.18.32
 Port 100
 Secret tserver1
 Phases accounting, authentication and authorization:
config ras server 10.50.18.32 port 100
config ras server 10.50.18.32 secret tserver1
config ras server 10.50.18.32 phase accounting authentication
authorization
3. Enable RAS accounting:
config ras accounting enable
4. Configure privilege level RAS authorization:
config ras authorization privilege

Note: RAS accounting and authorization take effect only when TACACS+ is
configured as the server type.
In this scenario, you will:
 Configure the RAS server type
 Configure the RAS server address and settings
 Enable RAS accounting
 Configure the RAS authorization mode
 Configure the number of times Remote RMX-3200 attempts to connect to the
RAS server
 Configure the RAS timeout period for a remote authentication attempt