Kentrox RMX-3200 - Setting Up the Initial Remote RMX-3200 Configuration

Remote RMX-3200 Version 5.2x Configuration Guide
Getting Started: Setting Up the Initial Remote RMX-3200 Configuration
2-5
Setting Up the Initial Remote RMX-3200 Configuration
To set up the initial Remote RMX-3200 configuration:
1. At the main prompt, add user
janedoe and assign the supervisor profile:
config users add janedoe supervisor
2. At the password prompt, enter the password mypassword. For security purposes,
the characters that you enter do not display, but appear as asterisks as shown
below:
**********
3. When prompted to confirm, re-enter the password. Again, the characters that you
enter appear as asterisks:
**********
4. Configure a banner with # as the delimiting character:
config banner #
The following message displays:
Enter the banner text. End the banner with a # character.
5. Configure the banner with display text This is my banner and the current date
and time:
This is my banner.
\d
\t
#
The prompt re-displays.
In this scenario, you will:
 Configure a new user with a supervisor profile
 Configure the login banner
 Configure a CLI session timeout
 Configure a hostname
 Configure an IP address for remote logins
 Configure a default route (gateway)
 Configure the remote access protocol to accept Telnet and FTP connections