Kentrox RMX-3200 - Directly Controlling a Relay Output

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Relay Outputs: Directly Controlling a Relay Output
20-8
Directly Controlling a Relay Output
To directly open and close a relay output:
1. Open
output 0/4:
diag output 0/4 open
2. Close output 0/4 for 10 seconds:
diag output 0/4 close 10
3. (optional) Verify the status of output 0/4:
show discrete outputs 0/4
The command response similar to the following displays:

Note: For details on the operation of the output relays for Remote RMX-3200, see
the Remote RMX-3200 Installation Guide.
In this scenario, you will directly open and close a relay output.
(Dub)>show discrete outputs 0/4
ID - 0/4
Description -
Resource State - unassigned
Value - open
(Dub)>