Kentrox RMX-3200 - Accessing the CLI Using a Remote Connection

Remote RMX-3200 Version 5.2x Configuration Guide
Getting Started: Accessing the CLI Using a Remote Connection
2-8
Accessing the CLI Using a Remote Connection
To access the CLI using a remote connection:
1. Use a PC or laptop with terminal emulation software to connect to Remote RMX-
3200. For information on operating your particular terminal emulation software,
refer to the documentation provided with the program.
2. Set up your terminal emulation software to connect using either a Telnet or an
SSH connection.

Notes: Individual procedures for making this connection will vary based on the
type of software you are using.
 To log into Remote RMX-3200 via SSH, you must execute command
config remote-access ssh-sftp enable
3. Enter the IP address of the Remote RMX-3200 to which you want to connect.
4. At the login prompt, enter your user name:
janedoe
5. At the password prompt, enter your password:
mypassword

Notes: Passwords are case-sensitive.
 admin is the default user name and password is the default password.
Remote RMX-3200 lets you log in only five times using the default
password. On your sixth login, Remote RMX-3200 will prompt you to
change the default password to a new password.
In this scenario, you will connect and log into Remote RMX-3200 remotely using
either a Telnet or an SSH connection.

Note: You can also connect remotely to Remote RMX-3200 using the HTTP or
HTTPS protocols.