Kentrox RMX-3200 - Sample Configuration for Sitebus Temperature Sensor

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Measurements and the Measurement Table: Configuring a Measurement Table Entry for a
Temperature Sensor
16-6
10. (optional) Verify that the measurement table entry has been configured properly:
show meas-table entries ExtTemp1
The command response similar to the following displays:
11. Save the configuration.
Sample Configuration for SiteBus Temperature Sensor
The following is a sample configuration for a measurement table entry for the SiteBus
temperature sensor used with RMB-1 and RMB-2. Adjust the sensor name, NE name
and other values to fit your specific implementation.
config meas-table entry TempSensor1
config meas-table entry TempSensor1 category Temp Sensor
config meas-table entry TempSensor1 description One Wire Temp
Sensor
config meas-table entry TempSensor1 originator sitebus
Temp/temperatureF
config meas-table entry TempSensor1 report-interval 15
config meas-table entry TempSensor1 band 20 110
config meas-table entry TempSensor1 hysteresis 2
config meas-table entry TempSensor1 maximum 150
config meas-table entry TempSensor1 minimum -10
config meas-table entry TempSensor1 ne-name Test_RMX3200
config meas-table entry TempSensor1 units degrees Fahrenheit
(Dub)>show meas-table entries ExtTemp1
Name - ExtTemp1 (static)
State - in-band
Originator - analog 0/4
Description - External temperature sensor
NE Name - sensorUnit
Category - envAlms
Report Interval - 0
Low-Band - 65.
High-Band - 80.
Hysteresis - 0.
Max-Limit - 130.
Min-Limit - -30.
Units - Degrees F
Current Value - 72
Interval Value - ?
Interval Minimum - ?
Interval Maximum - ?
Interval Average - ?
(Dub)>