Remote RMX-3200 Version 5.2x Configuration Guide
Configuring a Site VPN Connection: Verifying the VPN Connection from the Client
8-8
Verifying the VPN Connection from the Client
The VPN connection between the client and the Remote RMX-3200 can be
established in two ways. The connection can be made by launching an application
from Optima or by manually opening a connection from Redirect running on the client
computer. In either case, Optima or Redirect must be configured to use the site VPN.
Note: Refer to the Optima and Redirect documentation for additional information on
how to establish VPN connections.
Note: A connection from the client to the Remote RMX-3200 using Optima or
Redirect must first be opened before performing the following procedure.
To verify that a client is connected:
show controllers openvpn site clients
The command response similar to the following displays:
To verify the number of clients that are connected:
show controllers openvpn site client-count
The command response similar to the following displays:
Note: From the client, site NE 1 (IP address 192.168.111.100) and site NE 2
(192.168.111.101) can be accessed using ping, telnet, ssh, http, https or
snmp.
In this scenario, you will:
Verify that a client is connected
Verify the number of clients that are connected
(Dub)>show controllers openvpn site clients
>test addr10.39.7.9:1194 virtual-addr=192.168.101.6
connected=Mon Dec 10 13:27:30 EST 2012
rx-bytes=24617 tx-bytes=32053
(Dub)>
(Dub)>show controllers openvpn site client-count
Number of known clients: 1
Number of authenticated clients: 1
(Dub)>
To Next Page
Loading...
