Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Network Setup Parameters: Configuring NTP
5-5
Configuring NTP
To configure system clock parameters using the common clock time maintained by
the Remote RMX-3200 NTP server:
1. At the main prompt, configure the preferred NTP server with IP address
10.50.18.32:
config ntp server 10.50.18.32
Tip: The first server configured becomes the preferred server and the second
server configured becomes the secondary server, unless indicated
otherwise by entering
prefer as in step 2.
2. Configure the second NTP server with IP address 10.50.18.33 and set it as the
preferred server:
config ntp server 10.50.18.33 prefer
3. Define the minimum NTP polling interval as 7 (128 seconds) and maximum NTP
polling interval as
12 (4096 seconds):
config ntp poll-interval 7 12
Tip: The value for the interval is 2 raised to the power of the value entered.
4. Enable NTP on Remote RMX-3200:
config ntp enable
In this scenario, you will:
Configure a primary and secondary NTP server
Configure a minimum and maximum NTP polling interval
Enable NTP
To Next Page
Loading...
