Kentrox RMX-3200 - Configuring an IPv6 Address

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Network Setup Parameters: Configuring an IPv6 Address
5-4
Configuring an IPv6 Address
To configure an IPv6 address:
1. Configure interface bridge switch IPv6 address
fd10::39:0:0:100/64
config interface bridge switch ipv6 address fd10::39:0:0:100/64

Note: If an IPv6 router is advertising itself on the network, and IPv6 is enabled
on the interface, the Remote RMX-3200 may acquire an IPv6 address
from the router in addition to the address configured.
2. (Optional) Verify that the interface bridge switch has been configured properly
with the IPv6 address:
show interfaces bridge

Note: The command response will also contain the link-local IPv6 address.
The command response similar to the following displays:
3. Save the configuration.
In this scenario, you will configure an IPv6 address.
(Dub)>show interfaces bridge
bridge switch system-name=br_switch status=enabled link-state=up
address=10.39.50.10/16
link-local-address=169.254.166.87/16
ipv6 admin-state=enabled oper-state=enabled
address=fc10::39:240:72ff:fe0e:678d/64
valid=2591993sec preferred=604793sec dynamic
address=fd10::39:0:0:100/64
valid=forever preferred=forever
address=fd::39:0:0:100/64
valid=forever preferred=forever
address=fe80::240:72ff:fe0e:678d/64
valid=forever preferred=forever
(Dub)>