Kentrox RMX-3200 - Configuring a Mediation SNMP Network Element

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring the SNMP Proxy: Configuring a Mediation SNMP Network Element
22-15
Configuring a Mediation SNMP Network Element
To configure a mediation SNMP NE:
1. Configure the name,
ProxyNE, for the mediation SNMP NE:
config mediation snmpne ProxyNE
2. Configure the network element name, ProxyNE:
config mediation snmpne ProxyNE ne-name ProxyNE
3. Configure the host with an IP address of 10.40.65.90, port number 161,
community name
administrator and SNMP version number v1. These
parameters are used for polling the device.
config mediation snmpne ProxyNE host 10.40.65.90 161 administrator
v1
4. Configure the category as NECategory:
config mediation snmpne ProxyNE category NECategory
5. Configure status point ethernet1 with a link to the previously defined
ifEntryDef point template, a replaceable parameter name ifIndex and a value
for that parameter as
1:
config mediation snmpne ProxyNE point ethernet1 ifEntryDef ifIndex
1
6. Configure status point ethernet2 with a link to the previously defined
ifEntryDef point template, a replaceable parameter name ifIndex and a value
for that parameter as
2:
config mediation snmpne ProxyNE point ethernet2 ifEntryDef ifIndex
2
7. Configure an event named reboot, with a link to the previously defined
coldStartDef event template:
config mediation snmpne ProxyNE event reboot coldStartDef
In this scenario, you will configure information specific to a mediation SNMP NE
including:
 The host parameters
 A link to the previously defined event template, coldStartDef, which defines
the associated event
 A link to the previously defined point template, ifEntryDef, which defines the
associated event
 A link to the previously defined measurement template, alTableDef, which
defines a means of obtaining a value for a point on a proxied NE.