Remote RMX-3200 Version 5.2x Configuration Guide
Configuring DHCP: Configuring a Host on a DHCP Server
19-7
Configuring a Host on a DHCP Server
To configure a host on a DHCP server:
1. Configure host
firstHostConfig with hardware address 12:e3:a2:45:c5:b3:
config dhcp-server host firstHostConfig hardware-address
12:e3:a2:45:c5:b3
2. Configure host firstHostConfig with IP address 234.55.83.4:
config dhcp-server host firstHostConfig ip address 234.55.83.4
Note: The host IP address must be within one of the subnetworks being served
by the DHCP server. For more information, refer to section
Configuring a
DHCP Server Subnet on page 19-5.
3. (optional) Verify that the DHCP server has been configured properly:
show dhcp-server
The command response similar to the following displays:
4. Save the configuration.
In this scenario, you will:
Configure a DHCP server host
Configure a host hardware address
Configure a host IP address.
(Dub)>show dhcp-server
Admin State: disabled
Broadcast: enabled
Authority: enabled
Config file:
Note: User specified configuration files will override configured
DHCP server settings.
Interfaces:
bridge switch
Subnets:
234.55.0.0/16 range=234.55.83.2/234.55.83.30 router=234.55.83.1
default-lease=36000 max-lease=40000
DNS:
10.51.2.67
Hosts:
firstHostConfig MAC=12:E3:A2:45:C5:B3 IP=234.55.83.4
(Dub)>
To Next Page
Loading...
