Kentrox RMX-3200 - Configuring a Virtual TL1 NE

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring and Connecting TL1 Infrastructure: Configuring a Virtual TL1 NE
18-4
Configuring a Virtual TL1 NE
To configure a virtual TL1 NE:
1. At the main prompt, configure a user with login name
JohnDoe and password
Password for tl1ne 2:
config mediation tl1ne 2 user JohnDoe Password
2. Configure tl1ne 2 and its TID as mytid:
config mediation tl1ne 2 tid mytid
3. Enable tl1ne 2:
config mediation tl1ne 2 enable
4. Configure tl1ne 2 to send autonomous messages without a login:
config mediation tl1ne 2 automsgs nologon
5. Configure tl1ne 2 to send header messages without a login:
config mediation tl1ne 2 rtrvhdr nologon
6. (optional) Verify that tl1ne 2 has been configured properly:
show mediation tl1nes 2
The command response similar to the following displays:
7. Save the configuration.
In this scenario, you will configure the login information,
TID and message settings
for a virtual TL1 NE.

Note: A virtual NE listens for a connection from a TL1 multiplexer above it in the
TL1 infrastructure. Once a multiplexer has made a connection to the VNE, a
user or OSS can log in using the ACT-USER command. Currently, each
VNE supports a single user session.
(Dub)>show mediation tl1nes 2
NE-ID - 2
State - enabled
AutoMsgs - nologon
RtrvHdr - nologon
TID - mytid
Description:
Users:
UID PID
---------- ----------
JohnDoe Password
(Dub)>