Kentrox RMX-3200 - Configuring an Alarm Entry for Ethernet Interface MAC Security Violations

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Alarm Entries in the Central Alarm Table: Configuring an Alarm Entry for Ethernet Interface
MAC Security Violations
15-10
Configuring an Alarm Entry for Ethernet Interface MAC
Security Violations
To configure the MAC security violation alarm entry:
1. At the main prompt, configure description
MAC security violation:
config alarm-entry MACviolation description MAC security violation
2. Enable SNMP trap alarm protocol support:
config alarm-entry MACviolation trap enable
3. Configure category name Equipment:
config alarm-entry MACviolation category Equipment
4. Configure network element name discretePanel:
config alarm-entry MACviolation ne-name discretePanel
5. Configure an event for alarm entry MACviolation with the following settings:
 Event originator ethernet 3
 Event trigger mac-violation
 Event severity level major
 Alarm event message A MAC violation has occurred.
config alarm-entry MACviolation event ethernet 3 mac-violation
major A MAC violation has occurred
In this scenario, you will:
 Configure an alarm entry description
 Configure SNMP alarm protocol support for the alarm entry
 Configure a category name for the alarm entry
 Configure a network element name for the alarm entry
 Configure an alarm action that signals that a MAC security violation has
occurred.
Important: This scenario does not show how to configure the Ethernet port that is
associated with the alarm entry. For information on configuring
Ethernet ports, refer to command
config controller ethernet in
the Remote RMX-3200 Command Reference Guide.