Kentrox RMX-3200 - Using the serial-port Wizard

Remote RMX-3200 Version 5.2x Configuration Guide
Using Configuration Wizards: Using the serial-port Wizard
26-8
Using the serial-port Wizard
To configure an Remote RMX-3200 serial port:
1. From the main prompt, access the
serial-port wizard:
config use-wizard serial-port
The serial port wizard screen displays:
2. Enter the desired port number.
The wizard states which port is currently selected and lists options for:
 Choosing a different port (1 - 8)
 Configuring the selected port
 Ending the configuration
3. Select one of the options.
4. (optional) Enter a description for the port when prompted.
The wizard lists the default line settings and asks if you would like to accept those
settings.
In this scenario, you will configure an Remote RMX-3200 serial port with the serial-
port wizard.
(Dub)>config use-wizard serial-port
------------------------------------
----- serial port setup wizard -----
------------------------------------
This wizard configures serial ports.
An asterisk (*) in a selection list denotes the default value.
Ctrl-c aborts the wizard.
NOTE:
This wizard provides only basic configuration. For additional
configuration options, consult the command reference guide.
Enter number of the unit containing the port(s) to configure. Use 0 or blank
for the base unit. Use 1-12 for a peripheral unit.
Enter unit number (leave blank for base unit):
Port currently selected is 1
<port number> choose a different port (range 1-8)
(c) configure this port
(d) done
Choose option (leave blank to skip this port):