Remote RMX-3200 Version 5.2x Configuration Guide
Using Configuration Wizards: Using the serial-port Wizard
26-9
5. (optional) Enter the desired line settings. The following settings are configurable:
The line mode
The baud rate
The parity
The number of databits
The number of stop bits
The wizard asks you to select an application for the serial port. Application options
include terminal server, serial-to-IP, TBOS, or none (basic async port).
6. Select an application for the serial port.
Note: The remaining prompts for the serial port configuration will vary based
upon the application you select.
7. Enter the desired values for the application as prompted.
8. If desired, follow this procedure again to configure another serial port.
9. When you are finished configuring the ports, select one of the following options
when prompted:
(a) Apply the settings to running-config
(s) Save the commands to a patch configuration file
(v) View the commands
(c) Cancel.
You are returned to the main CLI when complete.
To Next Page
Loading...
