Kentrox RMX-3200 - Configuring T1;E1 Controller Channel Group Settings

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Controllers and Interfaces: Configuring T1/E1 Controller Channel Group Settings
7-5
Configuring T1/E1 Controller Channel Group Settings
To configure the T1/E1 controller channel group settings:
1. At the main prompt, configure the controller speed as
64 kbps for serial controller
7:
config controller serial wan/1 channel-group group speed 64

Note: 64 can be used only when the bit-level encoding method for the controller
is B8ZS.
2. Configure channel group
group to include DS0 channels 1-5,7-16:
config controller serial wan/1 channel-group group timeslot 1-5,7-
16
3. Enable channel group group:
config controller serial wan/1 channel-group group enable
In this scenario, you will:
 Configure the controller speed
 Configure the DS0 channels to include in the channel group
 Enable the channel group.