7-1
7
Configuring Controllers and
Interfaces
This chapter provides step-by-step scenarios on how to configure the basic parameters for a
T1/E1 serial controller and interface (known as IPCP); a T1/E1 controller as part of a bridge
(known as BCP); PPPoE (Point-to-Point Protocol over Ethernet) encapsulation settings; and port
based VLAN identifiers.
Guide to this Chapter
T1 and E1 Overview
Configuring T1/E1 Line Settings
Configuring T1/E1 Controller Channel Group Settings
Configuring T1/E1 Line Encapsulation Settings
Configuring T1/E1 Interface Settings
PPPoE Overview
Configuring PPPoE Encapsulation Settings
Port VLAN Overview
Configuring a Port VLAN
To Next Page
Loading...
