Kentrox RMX-3200 - Configuring a Telnet to Asynchronous Serial Connection

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Mediation Connections: Configuring a Telnet to Asynchronous Serial Connection
17-7
Configuring a Telnet to Asynchronous Serial Connection
To configure a Telnet to asynchronous serial connection:
1. Configure event
IncTelnetConn to signal that an incoming telnet connection
request has been received on port
60002 at IP address 10.40.57.5:
config event IncTelnetConn content telnet 10.40.57.5:60002
incoming-connection
2. Configure response telnet60002ToSerial5 to connect Telnet port 60002 at IP
address
10.40.57.5 to destination serial 5:
config response telnet60002ToSerial5 content telnet
10.40.57.5:60002 connect dest serial 5
3. Configure response telnet60002ToSerial5 to cause a Telnet connection from
port
60002 at IP address 10.40.57.5 to operate in binary mode:
config response telnet60002ToSerial5 content telnet
10.40.57.5:60002 connect options -b
4. Configure action telnetToSerial to associate event IncTelnetConn with
response
telnet60002ToSerial5:
config action telnetToSerial event IncTelnetConn response
telnet60002ToSerial5
In this scenario, you will configure a mediation connection between a Telnet port
and an asynchronous serial controller. You will set up an action, event and
response that cause the Telnet port and controller to connect.