Kentrox RMX-3200 - Configuring Dynamic Memory for a Job

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Jobs: Configuring Dynamic Memory for a Job
23-13
Configuring Dynamic Memory for a Job
To configure dynamic memory for a job:
1. At the main prompt, configure Remote RMX-3200 to use
2024 kilobytes of
dynamic memory while running job
printlog:
config jobs name printlog memory 2024
2. (optional) Verify that the dynamic memory has been configured properly for job
printlog:
show jobs name printlog status
The command response similar to the following displays:
3. Save the configuration.
In this scenario, you will configure the amount of dynamic memory that Remote
RMX-3200 can use while running
job printlog.
(Dub)>show jobs name printlog status
Job: printlog
Package:
Min version: any
Script:
Title:
Cron start: disabled
Start at boot: disabled
Memory limit (Kb): 2024
Stack size (Kb): 1024
Output capture: enabled
Max start attempts: 1
Run state: idle
(Dub)>