Kentrox RMX-3200 - Configuring DHCP Client Support

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring DHCP: Configuring DHCP Client Support
19-9
Configuring DHCP Client Support
To enable DHCP client support and configure the retry-timeout interval:
1. Enable DHCP client support:
config interface bridge switch ip dhcp enable
2. Configure the DHCP retry-timeout value as 10 minutes:
config interface bridge switch ip dhcp retry-timeout 10
3. (optional) Verify that the DHCP client settings have been configured properly:
show interface bridge switch
The command response similar to the following displays:

Note: The DHCP-related statements (shown below in boldface type) do not
appear unless DHCP client support is enabled.
4. Save the configuration.
In this scenario, you will enable DHCP client support and configure a ten-minute
interval for Remote RMX-3200 to retry contacting the DHCP server.

Note: DHCP client support cannot be enabled on the bridge group switch if a
static IP address has already been configured. You must remove the static
IP address before enabling DHCP client support.
(Dub)>show interface bridge switch
bridge switch system-name=br_switch
status=enabled link-state=up
address=10.44.57.5/16
dhcp-status=enabled dhcp-state=bound
dhcp-retry-timeout=10
dhcp-address=10.44.7.8/16
dhcp-lease-acquired=Fri Apr 16 13:57:37 EST 2010
dhcp-lease-expires=Sun Apr 18 13:57:37 EST 2010
dhcp-routers=10.44.0.1 dhcp-server-id=10.25.2.102
Stats: Bytes Packets Errors Dropped Overrun Framing
Rx 2348892 12929 0 0 0 0
Tx 2050152 11687 0 0 0 0
ethernet 1
Stats: Bytes Packets Errors Dropped Overrun Framing
Rx 2587084 12964 0 0 0 0
Tx 2618834 19175 0 0 0 0
ethernet 2
Stats: Bytes Packets Errors Dropped Overrun Framing
Rx 0 0 0 0 0 0
Tx 0 0 0 0 0 0
--More--