Kentrox RMX-3200 - Configuring Custom System Clock Settings

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Network Setup Parameters: Configuring System Clock Settings
5-8
4. (optional) Verify that the clock parameters have been configured properly:
show clock
The command response similar to the following displays:
Tip: In the command response for show clock, the name assigned to indicate
that daylight savings is enabled will appear in the timestamp during daylight
savings. After daylight savings, the name of the configured timezone will
appear in the timestamp.
5. Save the configuration.
Configuring Custom System Clock Settings
If you configure the timezone in custom mode, you can use subcommands to
customize the daylight savings parameters.
Important: You must disable NTP before you can configure the Remote RMX-3200
system clock locally.
To configure custom system clock settings:
1. At the
config clock prompt, configure the timezone as EST with an offset of
-5:00 and set the daylight savings configuration in the custom mode:
config clock timezone custom EST -5:00
(Dub)>show clock
Fri Apr 9 11:22:30 EDT 2010
Uptime 4 days, 0:17
The timezone is named EST and has an offset of -05:00 GMT.
Daylight savings time is named EDT and using default U.S rules.
Log timestamps are using GMT.
(Dub)>
In this scenario, you will:
 Configure the timezone in custom mode
 Enable daylight savings in custom mode
 Configure custom daylight savings time parameters