Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Alarm Entries in the Central Alarm Table: Overview
15-2
Overview
The central alarm table collects and communicates the state of all alarms reported by
Remote RMX-3200. It is a table of alarm entries that contains information for each
attainable severity level and has the following features:
Event/alarm associations—The central alarm table lets users associate events
with alarm responses in a single command. This is easier than configuring events
and alarm responses using the action subsystem, which requires three
commands for associating events with alarm responses.
Alarm Nagging—Alarm nagging causes an alarm entry to send an alarm message
in all formats enabled for that entry at a specified time interval. For information
about configuring the alarm
nagging interval, refer to section Configuring an
Alarm Entry for a Temperature Sensor on page 15-4.
Alarm reporting in a variety of formats—The central alarm table can report alarm
statuses in raw, SNMP, or TL1 format. For more information on these formats,
refer to section
Alarm Protocol Formats on page 15-3.
For information about commands that configure central alarm table entries and data,
refer to the Remote RMX-3200 Command Reference Guide.
To Next Page
Loading...
