Kentrox RMX-3200 - Configuring a Mediation SNMP Point Template

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring the SNMP Proxy: Configuring a Mediation SNMP Point Template
22-6
Configuring a Mediation SNMP Point Template
To configure a mediation SNMP point template:
1. Configure the point template name
ifEntryDef:
config mediation snmp point-template ifEntryDef
2. (optional) Configure an associated description Entry in IfTable:
config mediation snmp point-template ifEntryDef description Entry
in IfTable
3. Configure the dynamic poll table with the following settings:
 table oid .1.3.6.1.2.1.2.2.1
 match column (number) 2
 match value (for specified column) $(ifDescr)
 state (table) column 8
config mediation snmp point-template ifEntryDef
poll-table .1.3.6.1.2.1.2.2.1 2 $(ifDescr) 8

Note: If you configure a dynamic poll table (Step 3), you will not configure a poll ID
(Step 4) and vice versa.
4. Configure the poll OID
.1.3.6.1.2.1.2.2.1.8.$(ifIndex)for template
ifEntryDef:
config mediation snmp point-template ifEntryDef poll-oid
.1.3.6.1.2.1.2.2.1.8.$(ifIndex)
5. Configure the Up state:
config mediation snmp point-template ifEntryDef state up
In this scenario, you will configure a mediation SNMP point template named
ifEntryDef, which is a template for a row in the interface table on the proxied NE.
For each state (up and down) you will configure the:
 poll value
 dynamic poll table and trap map, or the poll OID
 trap OID
 varbind match
 severity
 message
 poll default state