Kentrox RMX-3200 - Assigning IP Addresses to Technician Laptops

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Technician Laptop Access for Remote RMX-3200: Assigning IP Addresses to Technician
Laptops
13-4
Assigning IP Addresses to Technician Laptops
To configure the DHCP server to assign IP addresses to technician laptops:
1. Enable the DHCP server:
config dhcp-server enable
2. Configure secondary bridge switch IP address 10.10.10.1/24:
config interface bridge switch ip address 10.10.10.1/24 secondary
Important: This step is important because an interface must exist on the same
subnet that the DHCP server will be servicing. If this interface does
not exist, the DHCP server will not start up.
3. Configure the DHCP server interface as
bridge switch:
config dhcp-server interface bridge switch
4. Configure the DHCP server subnet as 10.10.10.0/24:
config dhcp-server subnet 10.10.10.0/24
5. Configure the DHCP server router as 10.10.10.1:
config dhcp-server subnet 10.10.10.0/24 router 10.10.10.1
Remote RMX-3200 uses the DHCP server to assign IP addresses to network
devices. CLI commands are entered to specify valid ranges of IP addresses that
may be assigned.
Important: For a laptop to access the network through Remote RMX-3200 using
this procedure, the laptop must be configured to obtain its IP address
automatically.
In this scenario, you will:
 Enable the DHCP server
 Configure a secondary bridge switch IP address
 Configure the DHCP server interface
 Configure the DHCP server subnet
 Configure the DHCP server router
 Configure the DHCP server IP address range
 Configure the default time that a network device can keep a DHCP
server-assigned IP address
 Configure the maximum time that a network device can keep a DHCP
server-assigned IP address.