Kentrox RMX-3200 - Configuring Job Start Times

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Jobs: Configuring Job Start Times
23-12
Configuring Job Start Times
To configure start times for a job:
1. At the main prompt, configure job
printlog to start on August 7 and to run
through September 30 every Monday, Wednesday and Friday at 12:30 p.m., 5:30
p.m. and 7:30 p.m.:
config jobs name printlog start-at 8-9 7-30 12,17,19 30 1,3,5
A start-at index number of 1 is assigned.
2. (optional) Verify that job
printlog has been configured with the proper starting
times:
show jobs name printlog starts *
The command response similar to the following displays:
3. Save the configuration.
In this scenario, you will configure a
job to start on August 7 and to run through
September 30 at 12:30 p.m., 5:30 p.m. and 7:30 p.m. every Monday, Wednesday
and Friday.
(Dub)>show jobs name printlog starts *
Cron start: disabled
Start at bootup: disabled
Start-at index: 1
Month: 8-9
Day: 7-30
Hour: 12,17,19
Minute: 30
Weekday: 1,3,5
No scheduled start time
(Dub)>