Remote RMX-3200 Version 5.2x Configuration Guide
Configuring a Wireless Network with Remote RMX-3200: Getting Started
11-2
Getting Started
This section discusses the following topics:
Wireless Network Overview
Required Components
Initial Setup
Wireless Network Overview
Remote RMX-3200 models can be equipped with EvDO or UMTS modules used to
locate Remote RMX-3200s in areas that do not have traditional WAN connectivity.
Additionally, Remote RMX-3200s located at cell sites do not require a dedicated
T1/E1 channel for management. Full T1/E1 bandwidth is available for wireless
customers and management data can be carried over the customer network.
Note: For details on the available Remote RMX-3200 WAN modules, see Appendix
B : WAN Port Availability.
A wireless Remote RMX-3200 should appear as a wired extension of the
management network. The goal is to provide two-way, reliable connections with no
restrictions on protocols over the network.
The wireless Remote RMX-3200 communicates with the service provider’s
management network by delivering alarms to it. The management network tries to
establish connections to Remote RMX-3200 or to connected network elements.
Required Components
When operating in a wireless network, Remote RMX-3200 works in conjunction with
the following Kentrox products:
Connect SCS
Connect SCS acts as the VPN server for Remote RMX-3200. For more information
about Connect SCS, refer to the Connect SCS Configuration Guide.
To Next Page
Loading...