Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Alarm Entries in the Central Alarm Table: Alarm Protocol Formats
15-3
Alarm Protocol Formats
The central alarm table supports multiple alarm protocol formats, including:
Raw
SNMP
TL1
You can enable and disable each alarm protocol format independently of the others
(meaning that you can have more than one format enabled at a time).
Raw
The central alarm table supports raw alarm output that can be used for alarm formats
that are not directly supported by Remote RMX-3200. A script or application can take
the alarm information from the raw output and translate it into any type of alarm
message.
SNMP
The central alarm table supports SNMP through alarm traps in the aiMediationV2.mib.
Alarm traps are sent to all enabled SNMP management hosts. In order to receive
alarm traps, at least one SNMP management host must be configured.
TL1
The central alarm table supports TL1 reporting through virtual TL1 NEs. You must
configure and enable the desired virtual TL1 NEs to use them with the central alarm
table.
To Next Page
Loading...
