Kentrox RMX-3200 - Configuring an Alarm Entry for a Telnet Connection that Comes Up

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Alarm Entries in the Central Alarm Table: Configuring an Alarm Entry for a Telnet Connection
that Comes Up
15-18
Configuring an Alarm Entry for a Telnet Connection that
Comes Up
To configure the Telnet connection up alarm entry:
1. At the main prompt, configure description
Telnet connection up:
config alarm-entry TelnetConnUp description Telnet connection up
2. Enable SNMP trap alarm protocol support:
config alarm-entry TelnetConnUp trap enable
3. Configure an event for alarm entry TelnetConnUp with the following settings:
 Event originator telnet 192.168.0.4:6001
 Event trigger conn-up
 Event severity level normal
 Alarm event message Telnet connection now up.
config alarm-entry TelnetConnUp event telnet 192.168.0.4:6001
conn-up normal Telnet connection now up
Tip: This same scenario can be followed to configure a connection up alarm entry for
SSH. Simply substitute SSH for Telnet.
In this scenario, you will:
 Configure an alarm entry description
 Configure SNMP alarm protocol support
 Configure an alarm action that signals that a Telnet connection has come up.