Kentrox RMX-3200 - Appendix C: Command Identifications

C-1
C
Command Identifications
Command identifications are used when including and excluding commands for a
user-defined profile. The IDs are contained in the supervisor command tree. For
information on configuring user-defined profiles, see
Creating a Custom Profile on
page 3-6.
The following table contains some of the valid command identifications for the Remote
RMX-3200:
Commands Identifications
config /config
config action /config/action
config alarm-entry /config/alarm-entry
config apply-patch /config/apply-patch
config banner /config/banner
config clock /config/clock
config clock daylight-savings /config/clock/daylight-savings
config clock local-time /config/clock/local-time
config clock timezone /config/clock/timezone
config controller /config/controller
config controller bridge /config/controller/bridge
config controller ethernet /config/controller/eth
config controller ethernet assign /config/controller/eth/assign
config controller ethernet bridge /config/controller/eth/bridge
config controller ethernet description /config/controller/eth/description
config controller ethernet disable /config/controller/eth/disable
config controller ethernet enable /config/controller/eth/enable