Remote RMX-3200 Version 5.2x Configuration Guide
Backing Up and Restoring the Remote RMX-3200 Configuration: Backing Up the Configuration
A-2
Backing Up the Configuration
Important: There are two configuration files. The startup configuration file
(primary.cnf) is the configuration used to start Remote RMX-3200. The
running configuration file (running-config) includes configuration changes
that have been made since startup.
Note: This procedure refers only to the FTP utility for backing up the configuration.
However, you may be required to use an SFTP utility, depending on the
remote access protocol option. Refer to the remote access configuration
commands in the Remote RMX-3200 Command Reference Guide for
information on enabling FTP or SFTP.
To back up the configuration:
1. Using an FTP utility, connect to and log into Remote RMX-3200.
2. Change the current directory to the config directory on Remote RMX-3200.
3. Locate the Remote RMX-3200 configuration file (primary.cnf or running-config) in
the config directory.
4. Using ASCII mode, get the configuration file from the config directory on Remote
RMX-3200. The configuration file is copied to the working directory on your
workstation.
Note: The running-config file is an ASCII file—it should only be transferred with
an ASCII mode FTP.
5. Close the FTP connection to Remote RMX-3200 and exit the FTP utility.
In this scenario, you will back up the Remote RMX-3200 configuration file.
To Next Page
Loading...
