Remote RMX-3200 Version 5.2x Configuration Guide
Preface:
1-iv
Cautions and Warnings
Electrostatic Discharge Caution
CAUTION: Kentrox equipment and its peripherals contain electrostatic sensitive
components. Proper handling, shipping, and storage precautions must
be exercised:
You must remove and install cards in a static-free environment. Wear
an antistatic wrist strap that is plugged into the Kentrox equipment so
you are grounded at the same point as the equipment.
Do not remove cards from their antistatic plastic bags until you are
ready to install them into the chassis.
Immediately after you remove a card from the chassis, you must
insert it into its antistatic bag.
When the cards are not in use, keep them in their antistatic plastic
bags.
Do not ship or store cards near strong electrostatic, electromagnetic,
or radioactive fields.
Ground Caution
CAUTION: For Kentrox equipment to operate safely and correctly, there must be a
safety ground strap between the equipment ground bolts and the office
ground.
FCC Warning
The Federal Communications Commission has set limits for emitted radio
interference, and Remote RMX-3200 is constructed with this electromagnetic
interference (EMI) limitation in mind. Remote RMX-3200 is classified under FCC
regulations as a Class A device, that is, a device for use in commercial environments
and not in residential areas. This device has been tested and shown to comply with
the following FCC rule: Part 15 Subpart J. Operation of this equipment in a residential
area may cause interference to radio and TV reception, requiring the user to take
whatever steps are necessary to correct the interference.
Information is available from the FCC describing possible corrective actions. To
maintain low EMI levels, we suggest that you use only metal connectors and shielded
cable grounded to the frame.
Specifications are subject to change without notice.
To Next Page
Loading...
