Kentrox RMX-3200 - Configuring Cut-Through Support

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring TBOS Settings: Configuring Cut-Through Support
21-13
Configuring Cut-Through Support
To configure cut-through support:
1. Configure cut-through from TBOS serial port
5 to TCP port 50001:
config tbos port serial 5 cut-through port 50001
2. Enable cut-through on TBOS serial port 5:
config tbos port serial 5 cut-through enable
3. (optional) Verify that cut-through support has been enabled for TCP port 50001:
show tbos port serial 5
The command response similar to the following displays:
4. Save the configuration.
In this scenario, you will configure
cut-through support from a TBOS serial port to a
TCP port.
(Dub)>show tbos port serial 5
State: enabled
Description: TBOS port 5
Cut-Through:
IP Port: 50001
State: enabled
Display Poll State Equipment Type Description
------------------------------------------------------------------
1 enabled Alcatel_MDR4000E
2 enabled all
3 disabled none
4 disabled none
5 disabled none
6 disabled none
7 disabled none
8 disabled none
(Dub)>