Kentrox RMX-3200 - Using the initsetup Wizard

Remote RMX-3200 Version 5.2x Configuration Guide
Using Configuration Wizards: Using the initsetup Wizard
26-3
Using the initsetup Wizard
To configure the initial setup:
1. From the main prompt, access the
initsetup wizard:
config use-wizard initsetup
The initsetup wizard screen displays:
2. Enter the desired hostname.
3. Enter the desired IP address for the device when prompted.
4. Enter the desired subnet mask or mask length when prompted.
In this scenario, you will configure the initial setup for Remote RMX-3200 using the
initsetup wizard. The wizard prompts you for all of the required and optional
information.

Note: The running-config file is automatically saved to a network-recovery
file when you run the initsetup wizard and apply the output to the
running-config file. If the running configuration is lost, you can copy file
network-recovery to file running-config to restore the initial system
configuration.
(Dub)>config use-wizard initsetup
---------------------
----- initsetup -----
---------------------
This wizard configures initial connectivity settings.
An asterisk (*) in a selection list denotes the default value.
Ctrl-c aborts the wizard.
NOTE:
This wizard provides only basic configuration. For additional
configuration options, consult the command reference guide.
Hostname of this device: