Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Mediation Connections: Configuring a TCP to Asynchronous Serial Connection
17-6
5. Configure controller serial 4 to connect and disconnect as DCD goes active and
inactive:
config controller serial 4 connect mode dcd
config controller serial 4 disconnect mode dcd
6. Configure the application mode as destination:
config controller serial 4 application destination
7. (optional) Verify that a connection is established:
show connections
The command response similar to the following displays:
Note: The 4 that comes after the TCP port number is an internal reference
number generated by Remote RMX-3200.
8. Save the configuration.
(Dub)>show connections
tcp 10.40.57.5:40010:4 -> serial 4
(Dub)>
To Next Page
Loading...
