Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Controllers and Interfaces: Configuring T1/E1 Line Settings
7-4
5. (Optional) Verify that controller serial wan/1 has been configured properly:
show controller serial wan/1
The command response similar to the following displays (for a T1 controller):
6. Save the configuration.
(Dub)>show controllers serial wan/1
serial wan/1 status=enabled
resource-state=unassigned
rx-link-state=LOF
tx-link-state=up
local-loop=norm
remote-loop=norm
buildout=-7.5dB
clock=loop
framing=d4
linecode=b8zs
loop-detect=disable
framer-crc-errors=0
framing-errors=57562691
line-coding-violations=0
severely-errored-framing-events=0
desc=T1 port
channel-group=group status=enabled
system-name=hdlc0
speed=64
encap=ppp
timeslot=1-24
(Dub)>
To Next Page
Loading...
