Remote RMX-3200 Version 5.2x Configuration Guide
Using Configuration Wizards: Using the bistate-alarms Wizard
26-7
8. Enter a new normal state message or accept the default normal state message
when prompted.
9. (optional) Enter the desired nagging interval when prompted.
10. (optional) Enter the desired network element name for the alarm entry when
prompted.
11. (optional) Enter an alarm category for the alarm entry when prompted.
The wizard takes you back to the initial bi-state point prompt (configured in step
2).
12. If desired, follow this procedure again to configure another bi-state point.
13. When you are finished configuring points, select one of the following options
when prompted:
(a) Apply the settings to running-config
(s) Save the commands to a patch configuration file
(v) View the commands
(c) Cancel
You are returned to the main CLI when complete.
To Next Page
Loading...
