Kentrox RMX-3200 - Page 54

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Network Setup Parameters: Configuring NTP
5-6
5. (optional) Verify that the clock parameters have been configured properly:
running-config
The command response similar to the following displays:
Tip: You can also use the show ntp command to verify the NTP configuration.
6. Save the configuration.
(Dub)>running-config
# Product: Remote RMX
# Version: 3.30
# Created: 2010-11-22,12:32:11.0,-0800
# User: test
# Stage2 Version: 4.06
config banner #
This is my banner.
\d
\t
#
config hostname Dub
config ip domain-name www.Kentrox.com
config ip forward
config ip name-server 10.25.2.5
config ip name-server 10.25.2.20
config ip route default 10.40.0.1
config ntp enable
config ntp poll-interval 7 12
config ntp server 10.50.18.33 prefer
config ntp server 10.50.18.32
config timeout 20
config users add janedoe supervisor -e$1$KwadE3g5$OzZeYQxk1CqLoyvm8/5pU. -e$1$Kw
adE3g5$OzZeYQxk1CqLoyvm8/5pU.
config interface bridge switch ip address 10.40.57.90/16
(Dub)>